Seed Hawk Raven 2010 - Manual (Page 125)

5
Manual No. 016-3001-003 115
Using the Seed Hawk® Viper Pro System
3, CAN (Controller Area Network) Setup, for more information about programming and configuring
a CANbus system.
You can select different options to run for the job. The following features are available:
•
Product Application
•
Swath Guidance
•
Section Control
Product Application
The Product Application feature allows you to:
• Communicate with a Raven product control system
• Log an application
• Variable rate with reference to a prescription map
Note:
The multi-product variable rate (VRA) key must be purchased to variable rate more than one
product.
Viper handles the product selection in a sequential manner, so you must select the location on the unit from
where the product is applied. If you want to apply only products 4 and 5, you must select 5 for you product
selection. If you want to apply products 1, 4, and 5, you should still select 5 for your product selection.
The product selection screen references the number of product control channels on the vehicle, not the actual
number of products you are applying. For example, if you are applying only one liquid product, but the tank
contains a mixture of three different products, you must enter a 4 in the product selection screen (3 air cart bins
with 1 liquid product tank). This screen will only allow you to enter the number of products available for
application.
The Product Selection screen also allows the user to select the Enable Product Chaining option. With this
option selected, the user will be able to select which products to chain together and set the sequence in which
the products will be used. See the Product chaining section in Chapter 5 for more information on this feature.