Seed Hawk Raven 2010 - Manual (Page 48)

Chapter 3
38 Seed Hawk™ Viper Pro™ Installation & Operation Manual
Decimal Shift
Use the Decimal Shift feature to increase the system accuracy for low application rates. In the standard mode,
the Viper Pro displays values to one decimal place. With the Decimal Shift feature enabled, values will be
displayed to two decimal places.
Note:
After you have either enabled or disabled the Decimal Shift, verify all calibration values for
accuracy. Change settings as necessary.
Agitator
Enable or disable the vehicle’s agitator via the Viper Pro console using this option. Contact your local Raven
dealer for required hardware.
Display Smoothing
With the Display Smoothing feature enabled, the target rate displays as the R
A
(actual rate applied) on the
Viper Pro main screen as long as the target rate is within 10% of the actual application rate. The actual rate
displays if the vehicle does not reach the deadband within 10 seconds.
With Display Smoothing disabled, the actual application rate displays at all times as the R
A
in the Application
Rates area on the Viper Pro main screen.
Note:
The display smoothing feature is only active for products in Automatic control mode.
Ratio Rate
The Ratio Rate may be enabled or disabled to allow an injected chemical to be applied in ratio to the amount of
the carrier. The Ratio Rate should only be enabled with chemical injection applications.