Seed Hawk Raven 2010 - Manual (Page 49)

3
Manual No. 016-3001-003 39
CAN (Controller Area Network) Setup
Data Box 2 for Products 1-3
The information displayed in Data Box 2 is an overview of the settings for the selected product control node.
Note:
The selected product control node appears with a check mark in the corresponding radio button at
the top of Data Box 1. To switch the selected node, touch the radio button for the desired product
node.
For product nodes 1 through 3, the following settings will be displayed in Data Box 1:
Note:
The following sections offer descriptions of the various options and settings used with products 1
through 3. For descriptions of the settings used with products 4 and 5, see the Data Box 2 for
Products 4-5 section on page 43.
Data Box 2 Display Only Values
Data Box 2 displays the current value for the following items during an application:
Area/Hour
Displays the area per hour of product application. This is a display only.
•
Area/Hour (Display only)
•
Meter Cal
•
Pre Set PW
• Vol/Min (Display only) • Valve Cal • PW Freq
• Rate Cal • Min PW • Valve Delay
•
Rate Bump (+/-)
•
Max PW
•
PWM (Display only)
Status Screen Example
(Products 1-3)