Seed Hawk Raven 2010 - Manual (Page 47)

3
Manual No. 016-3001-003 37
CAN (Controller Area Network) Setup
Low Tank
Enter the limit for volume remaining in the tank. When the calculated volume remaining in the tank falls below
this setting, the Viper Pro will display an alert. The alarm shuts off either when the sections are turned off or if
you enter a new Low Tank value that is equal to or less than the current tank volume. If you enter a value of
zero in the field, the Low Tank alarm is disabled.
Node Settings Screen (Page 2)
Press the Next button on the first Node Settings screen to display the next page of available settings and
options.
Note:
The following sections offer descriptions of the various options and settings used with products 4
and 5. For descriptions of the settings used with products 1 through 3, see the Data Box 1 for
Products 1-3 section on page 32.
Zero Speed Shutoff
Use the Zero Speed Shutoff feature in Automatic Control Mode to allow the Viper Pro to turn off product
application if the vehicle speed drops below 0.7 MPH. To restart product application, cycle the master switch
‘Off’ and then ‘On.’ The Zero Speed Shutoff function will reactivate if the vehicle does not achieve a speed
greater than 0.7 MPH and maintain that speed for more than 10 seconds.
Vacuum/Bin Alarm
The Vacuum/Bin Alarm must be disabled during non-injection liquid applications.
The Vacuum Alarm option may be used when an injection pump is connected to the Viper Pro via a CAN
Product Control node capable of controlling an injection product. Enable the Vacuum Alarm to allow Viper Pro
to display an alert if the injection pump cannot draw product from the nurse tank.
Use the Bin Alarm during granular applications with an optional bin level sensor installed. With this feature
enabled, the Viper Pro will display an alert when the sensor detects the bin level falls below the sensor level.
Note:
Contact your local Raven dealer for information on injection systems or bin level sensors.
Flow/Shaft Alarm
You can enable or disable the Flow/Shaft alarm to help control a chemical injection. Disable this alarm when
you are not controlling a chemical injection.