Seed Hawk Raven 2010 - Manual (Page 124)

Chapter 5
114 Seed Hawk™ Viper Pro™ Installation & Operation Manual
Master.
Toggle the master switch to control product application and drill sections. The master switch must be in
the ON position to allow product application. Toggle the master switch to the OVERRIDE position to
momentarily override the SCT system and turn sections on.
Packing Pressure.
Use the packing pressure switch to increase or decrease the pressure on the packer
gauge wheels.
SBR.
Switch the seed between rows feature on or off. The status of this feature is displayed on the Viper Pro
main screen.
RWS.
Toggle the rear wheel steering feature on or off. The current status of this feature is displayed on the
Viper Pro main screen.
Note:
This feature is currently not available on the Seed Hawk Viper Pro system.
Product Switches.
Toggle product control manually by placing the product switch in the ON or MAN position.
To allow the Viper Pro to automatically adjust product rates, toggle the product switch to the AUTO position.
INC/DEC Switch.
Use the INC/DEC switch to quickly adjust the application rate of enabled products (see the
Seed Hawk Installation & Operation Manual to set and enable rate bump (+/-) values for specific products. For
products in manual (MAN) mode, hold the switch in the INC or DEC position to manually increase or decrease
the actual application rate. For products in automatic (AUTO) mode and rate bump enabled, hold the switch in
the INC or DEC position to increase or decrease the target application rate by the rate bump value.
Jobs
A job is a collection of information about the area of a field in which you are using Viper Pro to apply a product.
This information includes:
•
Prescription map information
•
Product controller system information
•
Section control information
•
Application information
From the Menu button on the Viper screen, you have the option to:
•
Start a new job
• Open an existing job, if you have one saved
• Create and edit application report information for jobs in progress
New Jobs
Viper allows you to either start a new job from scratch or to start a new job using an existing job boundary.
Once you have opened a job, you can access the tabs displayed on the main screen. Your access to the tabs
depend upon the features you purchased with the Viper Pro system. When you start a new job, Viper uses the
current date and time as the job name. You can change the job name to reflect your new job.
Note:
If you are running the Viper Pro system with a Raven CANbus system, make sure that all nodes
have been correctly programmed and that they are recognized by the Viper Pro. Review Chapter