Seed Hawk Raven 2010 - Manual (Page 45)

3
Manual No. 016-3001-003 35
CAN (Controller Area Network) Setup
Display Smoothing
With the display smoothing feature enabled, the target rate displays as the R
A
(actual rate applied) on the
Viper Pro main screen as long as the target rate is within 10% of the actual application rate. The actual rate
displays if the vehicle does not reach the deadband within 10 seconds.
With display smoothing disabled, the actual application rate displays at all times as the R
A
in the Application
Rates area on the Viper Pro main screen.
Note:
The display smoothing feature is only active for products in Automatic control mode.
Data Box 1 for Products 4-5
The information displayed in Data Box 1 is an overview of the settings for the selected product control node.
Note:
The selected product control node appears with a check mark in the corresponding radio button at
the top of Data Box 1. To switch the selected node, touch the radio button for the desired product
node.
For product nodes 4 or 5 the following settings will be displayed in Data Box 1:
• Dual Flow % • Flow/Shaft Alarm • Display Smoothing
•
Off Rate %
•
Vacuum/Bin Alarm
•
Agitator
• Low Tank • Decimal Shift • Ratio Rate
• Low Limit • Zero Speed Shutoff
Status Screen Example
(Products 4-5)