Seed Hawk Raven 2010 - Manual (Page 112)

Chapter 4
102 Seed Hawk™ Viper Pro™ Installation & Operation Manual
Setting up the GPS Comm Port to a Non-Raven DGPS Receiver
1.
Select Menu, then Setup, and Comm Ports. The GPS Comm Port Setup screen displays.
2.
Select Generic GPS.
3.
Press Auto Baud. Viper establishes communication with the DGPS receiver.
4.
Press OK once the communication is established.
Note:
If no communication is established, Viper Pro will display a ‘Not Found’ message. Press OK and
then re-check the receiver and cables and repeat step 3.
If an optional SmarTrax, automated steering system, will be used with the Viper Pro system, for
SmarTrax software versions:
• 3.2 and lower, set the baud rate to 38400.
• higher than 3.2, set the baud rate to 115200.
Raven GPS Setup
Select the Raven GPS option if a Raven DGPS Receiver is connected to the Viper Pro. This option will auto-
configure the communication ports for the following receivers:
Make sure that the Raven receiver is properly connected and powered up before configuring it with the Viper
Pro system.
• RPR 100S • Invicta 310
• RPR 100G • Phoenix 50
•
Invicta 110
•
Phoenix 200
• Invicta 115 • Phoenix 250
• Invicta 210