beautypg.com

Defining profile ready states – Watlow ANAWIN 2 User Manual

Page 55

background image

Setting Channel Parameters

AnaWin User’s Guide 5-15

To define an event, follow these steps:

1.

Use the Output ON check box—in the State panel—to specify
whether the digital output is on or off. Select Output ON to set the
digital output to On. Deselect Output ON to set the digital output to
Off.

2.

Use the Output Number pull-down list box to select the output
number you wish to toggle at the end of the segment you are edit-
ing.

3.

Click Save to save the event and return to the Ramp Soak Edit
screen. A notation representing the event you defined now appears
in the Event row. For example, the notation 16-ON indicates that
an event will turn output 16 on.

Defining Profile Ready States

Click the Ready button in the upper left corner of the Ramp Soak
Edit screen to display the Ramp Soak Ready State screen, shown in
Figure 5-19. From this screen you can define the profile’s ready state—
the setpoint and event outputs you want before the profile starts (i.e.
before the timer starts ticking). When you are done defining the ready
state, click the Segment Editor button to return to the Ramp Soak Edit
screen.

FIGURE 5-19

Ramp Soak Ready State Screen

The Ramp Soak Ready State screen includes a three-dimensional profile
view and the following controls that allow you to define the profile’s
ready state:

Ready Setpoint: Use the Ready Setpoint field to enter the setpoint you
want before the profile starts.

Number of repeat cycles: Use the Number of Repeat Cycles field to
enter the number of cycles (1 to 99) that you want the profile to repeat
automatically. For continuous cycling, enter 0.