Watlow ANAWIN 2 - Manual (Page 32)

4-4 AnaWin User’s Guide
Setting System Parameters
Under Limit Action: Sets a startup operation if the amount of time
AnaWin is powered down is less than the specified time limit.
Over Limit Action: Sets a startup operation if the amount of time
AnaWin is powered down is greater than the specified time limit.
You can choose from three options for the under and over limit actions:
• Read Parameters From Controller: Reads the operational parame-
ters from the controller on bootup.
• Send Parameters to Controller: Downloads parameters from
AnaWin to the controller(s). If you select this option, you can either
have AnaWin load the last recipe which was downloaded or any of
the recipes saved on the PC’s hard disk.
• Operator Select on Startup: Prompts the operator to choose to read
parameters from the controller or download a recipe when AnaWin
is launched.
Save
Click Save to save the Program Startup options you have set. Changes
made to other portions of the Preferences screen are saved immediately
when you make the changes.
Cancel
Click Cancel to cancel changes in the Program Startup panel.
NOTE
When using channel grouping, set options in the Program Startup
panel for each group.
Miscellaneous System Parameters
Figure 4-5 shows the miscellaneous system parameters available on the
Preferences screen. The following subsections describe these
parameters.
FIGURE 4-5 Miscellaneous Parameters on the Preferences Screen