Watlow ANAWIN 2 - Manual (Page 138)

C-6 AnaWin User’s Guide
AnaWin OLE Server
AWServerBusy (15): Returned by SetChannelDataValues if the server
is busy downloading values requested by the user or another client. If
this is received, the client should try again later.
AWStartingUp (16): When AnaWin starts up, it reads up the data
tables for all attached controllers. This can take several minutes,
depending on how many controllers are on the bus. During the startup
process, AnaWin responds to all data queries and download requests
with AWStartingUp. The client should wait until the startup process is
complete before sending or requesting data.
CLS/MLS Channel Parameters
The following table describes the valid channel parameters.
Parameter
Number
Parameter Description
0 Input Type
1 Heat Prop Band
2 Heat Integral
3 Heat Derivative
4 Heat Type
5 Control Mode
6 Heat Enable
7 Heat Action
8 Setpoint
9 Process Variable
10 Heat PID Filter
11 Heat PID Output %
12 Hi Process Alarm
13 Lo Process Alarm
14 Deviation Alarm
15 Alarm Deadband
16 Stpt Src Frm Chn
17 InputRange Hi PV
18 InputRange Lo PV
19 Input Decimals
20 Heat TP Time
21 Input Eng. Units
22 Inp Hi%Fullscale
23 Inp Lo%Fullscale
24 Heat/Cool Spread
25 HiProc Alm Out#