Watlow ANAWIN 2 - Manual (Page 45)

Setting Channel Parameters
AnaWin User’s Guide 5-5
Output
Use the Output tab, shown in Figure 5-6, to enable or disable outputs
and to choose the output signal type.
FIGURE 5-6 Channel Setup Output Tab
The Output tab includes two panels: one for output #1 (generally for
heat) and one for output #2 (generally for cool). When you select Time
Proportioning output, another field appears in which you can enter the
cycle time for the TP output. If you select SDAC output, the SDAC
Settings panel, shown in Figure 5-7, appears.
FIGURE 5-7 SDAC Settings Panel
Control
Use the Control tab, shown in Figure 5-8, to select a control mode
(Auto, Manual, or Tune) or the ramp/soak status (Start, Run, or Hold).
The mode or status you select here appears in the upper part of the
Channel Setup screen, in the channel summary area, as described in this
chapter.