beautypg.com

Using the fast selection button – Maple Systems HMI5000 Series User Manual

Page 142

background image

136

EZware5000 Series Programming Manual

1010-1007, Rev. 10

Using the Fast Selection Button

The fast selection button is used to display the Fast Selection window.
Pressing the button again causes the Fast Selection window to close.

Creating the Fast Selection Button

The fast selection button must be activated in the System Parameters in order
to have it display on the HMI. When enabled, the fast selection button is always
visible on the screen.

To display the fast selection button:

1. Select Edit > System Parameters. The System Parameters Setting Dialog

appears. Select the General tab.

2. In the Fast selection button section, select Enable from the Attribute drop-down menu.

3. Select either Right or Left from the Position drop-down menu to select whether the button will appear in the

right-lower corner or left-lower corner of the screen.