Vanguard Tri-Phase - Manual (Page 82)

TRI-PHASE OPERATING™ INSTRUCTIONS
82
16.21 Erase A Test Record Procedure
The following procedure allows the operator to erase a test record from FLASH EEPROM memory.
Table 11.0 Erase A Test Record Procedure
STEP DESCRIPTION DISPLAY ACTION
1 Select “Setup” from the “Main
Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
Press key number 2
Selection of 2 may be
made by turning the
Control Knob. Push
down Control Knob
after 2 is selected
2 Select “Save/Restore Record”
from the “Setup Menu” 1.RECORD ID .
2.TEST VOLTAGE
3.TEST FREQUENCY
4.PRINT RECORD
5.SAVE/RESTORE RECORD
6.SET TIME
Press key number 5
Selection of 5 may be
made by turning the
Control Knob. Push
down Control Knob
after 5 is selected
3 Select “Erase Record” from the
“Save/Restore Menu” 1.RESTORE RECORD .
2.SAVE RECORD
3.RECORD DIRECTORY
4.ERASE RECORD
Press key number 4
Selection of 4 may be
made by turning the
Control Knob. Push
down Control Knob
after 4 is selected
4 Select “Erase Single Record
Number” from the “Erase
Record Menu” ERASE RECORD
1.ERASE SINGLE RECORD .
2.ERASE ALL RECORDS
“STOP” TO EXIT
Press key number 1 or
push down on the
Control Knob
5 Enter record number to be
erased ERASE RECORD
NUMBER: Use keys 0-9 to enter
record number
(50 was entered)
6 Confirm record number ERASE RECORD
NUMBER: 50 Press “ENTER” key
or push down Control
Knob to confirm
(50 was keyed)
7 Record erased from FLASH
EEPROM ERASING RECORD
PLEASE WAIT… Wait for next display
8 Record number erased from
FLASH EEPROM confirmation RECORD NUMBER 50
ERASED! Press any key or push
down Control Knob
9 Option to choose erasing single
or all test records ERASE RECORD
1.ERASE SINGLE RECORD .
2.ERASE ALL RECORDS
“STOP” TO EXIT
Press the “STOP” key
to return to “Main
Menu”