Vanguard Tri-Phase - Manual (Page 59)

TRI-PHASE OPERATING™ INSTRUCTIONS
59
16.0 Test Record Options
16.1 Restore A Test Record To Print Procedure
The following procedure allows the operator to restore a test record from FLASH EEPROM.
Table 7.0 Restore A Test Record To Print Procedure
STEP DESCRIPTION DISPLAY ACTION
1 Select “Setup” from the
“Main Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
Press key number 2
Selection of 2 may be
made by turning the
Control Knob. Push
down Control Knob
after 2 is selected
2 Select “Save/Restore Record”
from the “Setup Menu” 1.RECORD ID .
2.TEST VOLTAGE
3.TEST FREQUENCY
4.PRINT RECORD
5.SAVE/RESTORE RECORD
6.SET TIME
Press key number 5
Selection of 5 may be
made by turning the
Control Knob. Push
down Control Knob
after 5 is selected
3 Select “Restore Record” from
the “Save/Restore Menu” 1.RESTORE RECORD .
2.SAVE RECORD
3.RECORD DIRECTORY
4.ERASE RECORD
Press key number 1
or push down Control
Knob
4 Select “Enter Record
Number” from the “Restore
Record Menu”
RESTORE RECORD
1.ENTER RECORD NUMBER .
2.SCROLL TO SELECT
Press key number 1
or push down on the
Control Knob
5 “Restore Record Number
Status” display
Enter record number to be
restored RESTORE RECORD
NUMBER: Use keys 0-9 to enter
record number
(41 was entered)
6 Confirm record number RESTORE RECORD
NUMBER: 41 Press “ENTER” key
to confirm
7 “Record Restored Menu”
Record recalled from FLASH
EEPROM to volatile memory RECORD RESTORED!
PRINT RECORD?
1.YES .
2.NO
Press key 1 or push
down Control Knob
8 “Print Record Menu” PRINT RECORD
1.PRINT TO LCD .
2.PRINT TO PRINTER
Press key number 2
Selection of 2 may be
made by turning the
Control Knob. Push
down Control Knob
after 2 is selected