Vanguard Tri-Phase - Manual (Page 18)

TRI-PHASE OPERATING™ INSTRUCTIONS
18
8.0 TRI-PHASE™ Printer and Printer Paper
The TRI-PHASE™ built-in thermal printer uses 4.5-inch wide thermal paper for printing test
results. In order to maintain the highest quality printing and to avoid paper jams we recommend
using the paper supplied by our factory. Paper can be ordered from the following sources.
Vanguard Instruments Co, Inc.
1520 S. Hellman Ave.
Ontario, CA 91761
Tel: 909-923-9390
Fax: 909-923-9391
Part Number: TP-4 Paper
OR
BG Instrument Co.
13607 E. Trent Ave.
Spokane, WA 99216
Tel: 888-244-4004
Fax: 509-893-9803
Part Number: TP4 paper
9.0 Memory Storage Capabilities
9.1 Test Record Memory Storage Capabilities
The TRI-PHASE™ is capable of storing up to 112 transformer test records in the on-board FLASH
EEPROM. The TRI-PHASE™ is capable of restoring test records from the on-board FLASH
EEPROM. After a test record is restored it may be viewed on the TRI-PHASE™ LCD screen
and/or transferred to a USB FLASH memory thumb drive, to a PC, or printed using the built-in
thermal printer. Storing more than 112 transformer test records requires a USB FLASH memory
thumb drive. A USB FLASH thumb drive is capable of storing 999 transformer test records.
9.2
Transformer Test Plan Memory Storage Capabilities
Each TRI-PHASE™ is capable of storing up to 128 Transformer Test Plans in the FLASH
EEPROM. Test plans allow the operator to perform a complete transformer test and obtain
PASS/FAIL results.
10.0 Operating Voltages
10.1 Operating Voltages
The TRI-PHASE™ operating voltage is 100-240Vac, 50/60Hz.
The TRI-PHASE™ has built-in ground fault isolation detection and will only operate with
operating voltages that are ground-fault isolated.