Vanguard Tri-Phase - Manual (Page 111)

TRI-PHASE OPERATING™ INSTRUCTIONS
111
19.0 Test Voltage Selection Procedure
Table 19 .0 shows the procedure to perform in order to select a transformer test voltage. Refer to
section 19.1 for a description of the available transformer test voltages.
Table 19.0 Transformer Test Voltage Selection Procedure
STEP DESCRIPTION DISPLAY ACTION
1 Select “Setup” from “Main
Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
Press key number 2
Selection of 2 may be
made by turning the
Control Knob. Push
down Control Knob
after 2 is selected
2 Select “Test Voltage” from the
“Setup Menu” 1.RECORD ID .
2.TEST VOLTAGE
3.TEST FREQUENCY
4.PRINT RECORD
5.SAVE/RESTORE RECORD
6.SET TIME
Press key number 2
Selection of 2 may be
made by turning the
Control Knob. Push
down Control Knob
after 2 is selected
3 Select “8 Volts” 1. 8 Volts .
2. 40 Volts
3. 100 Volts
Press key number 1 or
push down Control
Knob
(8 volts is selected)
4 Confirm test voltage 8 VOLTS SET Press any key or push
down Control Knob
5 Return to “Main Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
None