Vanguard Tri-Phase - Manual (Page 105)

TRI-PHASE OPERATING™ INSTRUCTIONS
105
17.15 Erase A Test Plan Procedure
The following procedure allows the operator to erase a test plan stored in FLASH EEPROM non-
volatile memory.
Table 17.0 Erase A Test Plan Procedure
STEP DESCRIPTION DISPLAY ACTION
1 Select “Test Plan” from the
“Main Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
Press key number 3
Selection of 3 may be
made by turning the
Control Knob. Push
down Control Knob
after 3 is selected
2 Select “Erase Test Plan” from
the “Setup Menu” 1.LOAD TEST PLAN .
2.UNLOAD TEST PLAN
3.PLAN DIRECTORY
4.PRINT TEST PLAN
5.ERASE TEST PLAN
6.SAVE TEST PLAN
Press key number 5
Selection of 5 may be
made by turning the
Control Knob. Push
down Control Knob
after 5 is selected
3 “Erase Test Plan Menu” ERASE TEST PLAN
1.ERASE SINGLE TEST PLAN .
2.ERASE ALL TEST PLANS
Press key number 1
or push down Control
Knob
4 “Erase Test Plan Number”
status window ERASE TEST PLAN
NUMBER: Use keys 0-9 to enter
test plan number
(1 was entered)
5 Confirm test plan number ERASE TEST PLAN
NUMBER: 1 Press “ENTER” key
or push down Control
Knob to confirm
6 Test plan erased from FLASH
EEPROM ERASING TEST PLAN
PLEASE WAIT… Wait for next display
7 Test plan number 5 erased
from FLASH EEPROM
confirmation TEST PLAN NUMBER 1
ERASED! Press any key or push
down Control Knob
8 Return to “Main Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
None