Vanguard Tri-Phase - Manual (Page 115)

TRI-PHASE OPERATING™ INSTRUCTIONS
115
21.0 Change Date And Time Procedure
The following procedure allows the operator to change the TRI-PHASE™ date and time.
Table 21.0 Change Date and Time Procedure
STEP DESCRIPTION DISPLAY ACTION
1 Select “Setup Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
Press key number 2
Selection of 2 may be
made by turning the
Control Knob. Push
down Control Knob
after 2 is selected
2 Select “Set Time Menu” 1.RECORD ID .
2.TEST VOLTAGE
3.TEST FREQUENCY
4.PRINT RECORD
5.SAVE/RESTORE RECORD
6.SET TIME
Press key number 6
Selection of 6 may be
made by turning the
Control Knob. Push
down Control Knob
after 6 is selected
3 “Enter Date” status display
Enter date using the
MM-DD-YY format ENTER DATE
MM-DD-YY
Use key numbers
0 through 9 for data
entry
4 “Enter Time” status display
Enter time using the
HH-MM-SS format ENTER TIME
HH-MM-SS
Use key numbers
0 through 9 for data
entry
5 “Main Menu” 1.RUN TEST .
2.SETUP
3.TEST PLAN
4.DIAGNOSTIC
TIME: 20:15:00
DATE: 07/16/08
Return to “Main
Menu”
NOTES:
The “Enter Time” status is displayed immediately after entering the last digit of the year from the
“Enter Date” status display.
The “Main Menu” is displayed immediately after entering the last digit of the seconds from the
“Enter Time” status display.