Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 90)

Teledyne LeCroy Global State and Sequence States
78 Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual
For the Global State there are only 2 Basic Resources for each Channel. Some
optimization is done internally to accommodate additional resources. You can keep
adding resources to the Global state so long as the Config is valid button stays green. If
you add a new event which is not valid a window appears with a message prompting
Invalid Recording Rules Configuration and the Config is valid button will turn red (see
Figure 5.27 on page 78 ).
Figure 5.27: Valid and Invalid Recording Rules Configuration Dialogs
5.18.2 Sequence State
The cell marked Drag an event here to add another sequence is the Sequence State. In
the Sequence State you can define a sequence of Events and Actions which the Summit
T3‐8 Analyzer looks for at pre‐determined times. Sequences are chains of events
culminating in a trigger or any other action. A sequence which is a separate chain of
events can be created with up to 16 states. A state is an event condition with an action