Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 212)

Teledyne LeCroy Corporation Using the CATC Trace Navigator
200 Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual
10.8.3 Navigator Ranges
You set the viewing range by dragging the yellow range delimiters along the slider. To set
the lowest packet viewable, drag the top delimiter up. As you do so, a tool tip appears to
indicate the current range. Stop dragging when you reach the desired lowest packet.
To set the highest packet viewable, drag the bottom delimiter down. Stop when the tool
tip indicates you are at the desired highest packet.
.
10.8.4 To Determine Current Position
In addition to the two range delimiters, the slider has a blue current‐position indicator
(see above). The current‐position indicator shows where you are in the CATC Trace
display with respect to the possible viewing range.
For example, suppose you set viewing range to packet 0 through packet 500 (the top
range delimiter is at packet 0, and the bottom range delimiter is at packet 500). If you
then move the current‐position indicator on the slider to midway between the top and
bottom delimiters, then packet 250 appears in the middle of the CATC Trace display.