Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 213)

Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual 201
Using the CATC Trace Navigator Teledyne LeCroy Corporation
10.8.5 To Reset Navigator Range
You can reset the Navigator range using the toolbar Navigator Range button. Press the
button to bring up the Navigator Range drop‐down menu.
The menu has the following options:
 Set Range to Whole Trace: Allows you to reset the range to include the entire
CATC Trace file contents. The top range delimiter is placed at the lowest packet
number in the CATC Trace. The bottom range delimiter is placed at the highest
packet number in the CATC Trace.
 Set Range Near Packet xxx: Allows you to collapse the range so that only the
packets immediately above and below the xxx packet are displayed. The xxx
packet is whatever packet is currently at the top in the CATC Trace display.
 Recently Used Ranges: Allows you to reset the range to any of a number of
recently used (previously set) ranges.
10.8.6 Navigator Panes
You can display any combination of CATC Trace Navigator panes.
From left to right, the panes are: Pre/Post Trigger, Errors, Traffic Type, Traffic Speed, and
Link Width. Each pane represents the entire CATC Trace with respect to different types of
information. The top of each pane represents the start of the CATC Trace file, and the
bottom represents the end of the CATC Trace file.