7 to show/hide navigator panes, 8 navigator slider, 9 catc trace navigator legend – Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual User Manual
Page 214
Teledyne LeCroy Corporation
Using the CATC Trace Navigator
202
Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual
Pre/Post Trigger: To view the trigger event in the CATC Trace and the relative size
of pre‐trigger and post‐trigger portions of the CATC Trace. The two portions are
set apart as different colors. The trigger event occurs at the point the two colors
meet.
Errors: To view any errors in the CATC Trace. A thin red line represents each error
in the pane.
Traffic Type: To view the types of packets that occur in the CATC Trace. A differ‐
ent color represents each packet type in the pane. The relative size of colored
portions in the pane corresponds to the amounts of the various packet types in
the CATC Trace. As described below, you can use the Navigator legend to change
the types of packets that take precedence in the display.
Traffic Speed: To view the speed that occurs in the CATC Trace.
Link Width: To view the link width that occurs in the CATC Trace.
10.8.7 To Show/Hide Navigator Panes
You can show/hide any of the panes using pop‐up menus accessible through left‐click the
Navigator Panes button or by right‐click anywhere in any CATC Trace Navigator pane.
10.8.8 Navigator Slider
The Navigator slider appears at the left of Navigator panes. The slider has yellow upper
and lower range delimiters and a blue current‐position indicator.
The Navigator slider lets you to set the range of packets viewable in the CATC Trace
display. In other words, it sets scrolling range of the display. You can scroll the display up
to the lowest packet number in the viewing range. You can scroll the display down to the
highest packet number in the viewing range.
10.8.9 CATC Trace Navigator Legend
The Navigator legend lets you control the display of content in Navigator panes.
You bring up the legend through the Navigator Pane’s drop‐down menu. Press the toolbar
Navigator Panes button to access the menu. Select the Legend option to bring up the
Navigator Legend dialog (see
).