Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 23)

Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual 11
Adding Devices Manually Teledyne LeCroy
Figure 3.5: Analyzer Devices Dialog
Note: To disconnect from a device, Click Setup > All Connected Devices. The Analyzer Devices dialog
displays, select the device, and click the Disconnect button.
3.4 Adding Devices Manually
You can locate and add a summit T3 located in a Ethernet subnet using the Add Device
button. Perform the following steps:
Click Setup ‐> All Connected Devices ‐> Add Device ‐> to display the Add Ethernet
Attached Device dialog.
Figure 3.6: Add Ethernet Attached Devices Dialog