Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 32)

Teledyne LeCroy Using Probes
20 Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual
Figure 3.18: Midbus Probe SSMP Cables
 1 Clock Cable ( see Figure 3.15 on page 18 ).
Connections for Gen2 Multi-lead Probe
Overview
Use a 1‐pod setup.
For x1 or x4, use the iPass Y‐cable to connect the probe data connectors on the Analyzer
to the pod(s).
On the other side of the pod, connect the flexible lead tips.
Connection Procedure
To connect Summit T3‐8 to the System Under Test (host platform or root complex under
test):
1. Connect the pods to the Analyzer using the iPass Y‐cable cables.
2. Connect the flexible lead tips to the pods using the SSMP cables.
3. Connect the lead tips to the system under test by soldering to the trace.
3.9.3 Example: Connecting the Summit T3-8 Analyzer to the Device Under Test
Using a Gen2 Multi-lead Probe for x8
Components
 2 iPass Straight cables for x8
Figure 3.19: iPass Straight Cables