Teledyne LeCroy WavePro Automation Command - Manual (Page 630)

Automation Command and Query Reference Manual - Processor Reference
RefPercentLevel Double
From 0 to 100 step 1 Range
Sets/Queries the test level for the reference trace in percent.
Description
' Visual Basic Script
Set app = CreateObject("LeCroy.XStreamDSO")
' Set parameter P3 to phase difference.
app.Measure.P3.ParamEngine = "Phase"
' Set the reference test level in percent.
app.Measure.P3.Operator.RefPercentLevel = 55
Example
RefSlope Enum
Sets/Queries the polarity of the measured reference transitions.
Description
' Visual Basic Script
Set app = CreateObject("LeCroy.XStreamDSO")
' Set parameter P1 to phase difference.
app.Measure.P1.ParamEngine = "Phase"
' Set the reference slope to negative.
app.Measure.P1.Operator.RefSlope = "Neg"
Example
Values
Both
Neg
Pos
SigFindLevel Action
Causes the engine to find a suitable level for either SigLevelType ("Absolute"or "Percent")
Description
SigHysteresis Double
From 0 to 10 step 0.1 Range
Sets/Queries the hysteresis range for the signal.
Description
' Visual Basic Script
Set app = CreateObject("LeCroy.XStreamDSO")
' Set parameter P3 to phase difference.
app.Measure.P3.ParamEngine = "Phase"
' Set the signal hysteresis in graticule divisions.
app.Measure.P3.Operator.SigHysteresis = 0.7
Example
2-131
918501 RevA