Teledyne LeCroy WavePro Automation Command - Manual (Page 484)

Automation Command and Query Reference Manual - Control Reference
PersistenceSaturation Integer
From 0 to 100 step 1 Range
Sets/Queries the saturation threshold for persisted waveforms.
All information at this level or above will be recorded with the same color or intensity.
See the general description above for a discussion of the locked and unlocked persistence modes.
Description
PersistenceTime Enum
Sets/Queries the state of the Persistence Time control. Controls the persistence decay time for this
trace. See the general description above for a discussion of the locked and unlocked persistence
modes.
Description
Values
0.5s
10s
1s
20s
2s
5s
Infinite
ShowLastTrace Bool
Sets/Queries the state of the Show Last Trace control. If True then when this trace is displayed in
persistence mode the last acquired waveform will be superimposed on the accumulating persistence
map.
See the general description above for a discussion of the locked and unlocked persistence modes.
Description
View Bool
Sets/Queries the trace's 'Viewed' state. When true, the trace is displayed on one of the display
graticules. Note that even when a trace is not visible, it may be used as a source for Math, Measure,
etc.
Description
RESULT app.WaveScan.ScanOverlay.Out.Result
WEBEDITOR app.WebEditor
This set of variables controls the web-editor which show the paths for data flow in the instrument.
This feature is not supported on all instruments. Currently it is supported on DDA and SDA models, and models with
XMAP and/or XMATH software options.
AddConnection([in] VARIANT destProcessor, [in] VARIANT destInputPin, [in] VA Method
AddPreview([in] VARIANT sourceProcessor, [in] VARIANT sourcePin, [in] BSTR Method
AddProcessor([in] VARIANT processorOrClassId, [in] BSTR requestedName, [in] Method
1-470
918501 RevA