Teledyne LeCroy WavePro Automation Command - Manual (Page 382)

Automation Command and Query Reference Manual - Control Reference
UpSampleRefClk Integer
From 1 to 50 step 1 Range
In some (rare) cases the clock signal may have a very fast edge relative to the scope's sample rate,
such that there are fewer than four samples on an edge. If that is so, it may help to reduce jitter on the
recovered clock to "upsample" the reference clock input. Determining the edge time uses cubic
interpolation, which works best when there are at least four samples on the edge. This control allows
you to specify the upsampling factor for the reference clock. In most cases, no upsampling is
needed. Nonetheless the default value for this control is 5, which should always be sufficient.
Description
SDAREFCLK app.SDA2.RefClkInput.SDARefClk
AxisXRotation Integer
From -90 to 90 step 1 Range
AxisYRotation Integer
From -90 to 90 step 1 Range
This control is used only when Persisted is true and Persistence3d is true. It controls rotation about
the Y axis of the view being persisted.
Description
ClearSweeps Action
Clear any accumulated result data. Useful for example to restart an average, or parameter statistics.
Description
AxisXRotation Integer
AxisYRotation Integer
ClearSweeps Action
LabelsPosition String
LabelsText String
Persist3DQuality Enum
PersistDotJoined Bool
Persisted Bool
Persistence3d Bool
PersistenceMonoChrome Bool
PersistenceSaturation Integer
PersistenceTime Enum
ShowLastTrace Bool
UseGrid String
View Bool
ViewLabels Bool
1-368
918501 RevA