Datamax-O'Neil H-Class Operator’s Manual User Manual
Page 89
H-Class
79
Prompts and Condition Messages (continued)
Displayed Message
Description
Action / State
REMOVE RIBBON
PRESS ANY KEY
The TEST Key was pressed
and held, or CLEAN HEAD
NOW was selected, but
ribbon is installed.
Remove ribbon and press
any key to proceed.
SAVE CHANGES?
Database changes were
made that require
confirmation.
Press YES to accept the
changes, or NO to discard
them.
If changes require a
reset, it will automatically be
invoked.
SUCCESSFUL
PRESS ANY KEY
The selected operation was
successfully completed.
Press any key to continue.
SYSTEM RESET
IN PROGRESS
A reset has occurred.
No action is required. Wait
briefly while the process
completes.
UNCALIBRATED
The Media Sensor is not
calibrated.
Perform calibration; see
Section 5.2.
WAITING FOR DATA
The SOP signal has been
received, but the printer
awaits label data.
Send a format from the
host.
WAITING FOR SIGNAL
The printer awaits a SOP
signal.
Send the SOP signal from
the applicator to the GPIO
port.
XXXX OF XXXX
PRINTING
A print job is in process, as
indicated by the batch total
and remaining label count.
No action is required.