Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 73)

H-Class 63
Communications (continued)
Menu Item Details
WLAN UNSECURED
Selects WiFi operation, where:
NO Exits the menu item without changing the current
settings.
YES Returns the NIC Adapter default values then sets
Discovery to “Enable,” SSID to “Any,” and WLAN
network type to “Infrastructure.”
WLAN ADHOC
Selects the DMXrfNetII default parameters, where:
NO Exits the menu item without changing the current
settings.
YES Restores WiFi defaults and initiates infrastructure
mode with an SSID of “Any.” All existing access point
associations will be deleted then established with the
closest available. (Useful when moving the printer to a
geographically distant location.)
SET FACTORY DEFAULTS
Returns the factory-programmed values, where:
NO
Exits the menu item without changing the current
settings.
YES
Restores the default settings.
WLAN Controls the communications settings for the
DMXfNetII Card, where:
MODE
Selects between Wired or WiFi operation, where:
ENABLED
Enables the WiFi interface.
DISABLED
Enables the wired interface.
BSS ADDRESS
Specifies the static IP address of the WiFi bridge
module.
 If DHCP is Enabled, this parameter will be ignored.
 000.000.000.000 Is the address in standard octet format.
SIGNAL READINGS
Displays the WLAN signal and noise ratios.
IP ADDRESS Specifies the static IP Address; where:
192.168.010.026 Is the address in standard octet format.