Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 69)

H-Class 59
System Settings (continued)
Menu Item Details
FAULT HANDLING
Determines the label disposition and user action if a
fault occurs, where:
LEVEL
Sets the printer response upon declaration of a fault,
where:
NO REPRINT
Stops printing and declares a fault. Then, following
correction of the problem, the FEED Key must be
pressed to clear the fault.
STANDARD
Stops printing and declares a fault. Then, following
correction of the problem, the FEED Key must be
pressed to clear the fault and reprint the label in
process.
VOID AND RETRY
Actions depend upon the RETRY COUNT:
• If the count has not been exceeded, VOID is printed
on the failed label and reprinting automatically
occurs;
•
If the count has been exceeded, printing stops and
a fault message is displayed. Then, following
correction of the problem, the FEED Key must be
pressed to clear the fault and reprint the label in
process; or,
•
If the CANCEL Key is pressed, reprinting is optional:
press NO to reprint; or, press YES to cancel the
reprint (and press YES again to cancel the batch.)
 Linear Scanner or RFID required.
DELAYED SCAN FAULT Increases throughput when bar codes reside near the
trailing edge of the label (in the direction of FEED).
 Linear Scanner or RFID required.
• If unreadable, the fault will occur after the next
label prints;
• The label immediately following a faulted label is
not scanned for errors; and,
•
VOID AND RETRY and REPRINT are automatically
disabled; the job can only be cancelled.
VOID RETRY & CONT. VOID is printed on a faulted label, with reprint
attempts occurring automatically, until the RETRY
COUNT has been exceeded and then that label will be
skipped (discarded) and printing will continue to the
next label in queue.
 Linear Scanner or RFID required.