Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 100)

90 H-Class
5.3.2 Level One Reset
Level One reset returns the factory default settings, or if saved a Factory Setting File. To
perform a Level One Reset:
• Select SET FACTORY DEFAULTS in the menu; see Section 4.2.4.
5.3.3 Level Two Reset
Level Two reset returns the printer to the firmware default settings and clears all
parameters. To perform a Level Two Reset:
• While turning ON the printer, press and hold the three Soft Keys (see Section 4.1)
until the SYSTEM RESET message flashes.

Calibration will be required; see Section 5.2.
5.4 Printhead Assembly Adjustments
Printhead Assembly Adjustments permit the mechanical compensation sometimes needed to
maintain print quality across the wide range of media types and sizes. The applicability and
adjustment methods for the printhead are described below.
5.4.1 Leveling Cam Adjustment
Whenever using narrow media (sizes that are less than the width of the printhead), adjust
the Leveling Cam for even pressure distribution.

If changing media sizes, readjust the Leveling Cam.