Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 112)

102 H-Class
Boot Loader Update Procedure
Step Displayed Message Action Comment(s)
A READY
Using the DOS copy
command (where
“filename” is the
program to be loaded
and “lpt1” is the selected
interface port), enter the
following:
copy filename lpt1:
As an example, this would be
entered as:
copy BOOTHE99_1101.bs lpt1
(Where lpt1 can differ to include
other ports, as available.)
The Ready Indicator will flash
as data is received.
B
UPGRADING
SOFTWARE
The new program is being
stored and verified.
C
H4212.173
07/04/2006
The printer has reset.
D READY
No action required.
The new application is now
running.
 If UNCALIBRATED is
displayed, see Section 3.4.

If the update failed, press and hold PAUSE and TEST while turning ON the printer
(see Section 4.1) then release the buttons after SEND SOFTWARE is displayed and
send the file as described above.
5.8 Fonts
Downloading Kanji, Hangul and Chinese Fonts
Fonts (KANJI, HANGUL and CHINESE) can be downloaded and stored in a printer module.
Font files are identified by part number and are protected by lock bits, which unlocked by
entering the correct 6-digit code via the control panel.
The printer can be easily and quickly updated:
A. Identify the desired version of firmware for the printer from our web site at
http://www.datamax-oneil.com and then download that file onto your computer’s
hard drive.