Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 78)

68 H-Class
Communications (continued)
Menu Item Details
CNTRL-CODES (DATA)
Determines how host Control Codes are handled,
where:
ENABLED
Processes software commands normally.
DISABLED
Controls the setting via the menu; see CONTROL
CODES, above.
STX-V SW SETTINGS
Determines how a host option enable command is
handled, where:
ENABLED
Processes the command normally.
DISABLED
Controls settings via the menu; see Section 4.2.3.
MAX LENGTH COMMAND
Determines how a host Maximum Label Length
(M) command is handled, where:
ENABLED
Processes software commands normally.
DISABLED
Controls the setting via the menu; see Section 4.2.1.
OPTION FEEDBACK
Allows feedback characters from an optional device to
be returned to the host device, in the format of
[CR], where:
A - Is the device type: R = RFID; and, S = Linear Scanner
B - Is the status: C = entire label complete; F = faulted
(failed) label; and, U = unknown
C - Is the number of expected reads, given in two
characters.
D - Is the number of good reads, given in two characters.
E - Is the internal Job and Sub Job Identifier, given in four
characters each.
F - Is the data read, delimited with semicolons (;) if
multiple reads.
DISABLED
Reports no data.
SCANNER
Reports Linear Scanner data.
RFID HEX
Reports RFID data in hexadecimal format.
RFID ASCII
Reports RFID data in an ASCII format.