Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 88)

78 H-Class
Prompts and Condition Messages (continued)
Displayed Message Description Action / State
CLEARING FAULTS
The FEED Key was pressed
following a fault and now
the printer is attempting to
clear the condition.
No action is required.
DMXNET INITIALIZING
The network card is
initializing, a normal
condition following power-up
or a reset.
No action is required.
Depending upon the
settings, it may take a few
minutes.
ENTER PASSWORD
0 - - -
This is the menu gateway
when security is enabled. A
four-digit password must be
entered for access.
Enter the correct password.
INVALID ENTRY
An incorrect entry has been
made. Enter a valid parameter to
continue.
NOT INSTALLED
The selected option or
feature cannot be found.
Verify that the option or
feature is correctly installed.
If so, call for service.
OFFLINE
The printer is in Menu or
Test Mode. The Menu or Test Button
was pressed.
PAUSED
The printer is in a paused
condition. The PAUSE Key was pressed
or Pause Mode is enabled.
PRINTHEAD CLEANING
The TEST Key was pressed
and held, or CLEAN HEAD
NOW was selected, and now
printhead cleaning is in
progress.
No action is required.
READY
The printer is waiting to
receive label formats,
downloads, etc.
Send a label format,
download, etc.