Datamax-O'Neil H-Class Operator’s Manual - Manual (Page 60)

50 H-Class
Printer Options (continued)
Menu Item Details
ERR ON PAUSE (APP2)
Sets the output when a service required fault occurs
(Applicator Interface Card Type 2 equipped only),
where:
ENABLED
Enables the output signal.
DISABLED
Disables the output signal.
REWINDER Controls the Powered Internal Rewinder option, where:
MODE
Sets the detection method and response of the printer,
where:
DISABLED
Disables the option.
AUTO
Enables the rewinder only when a Peel and Present
option is installed; however, no error will be generated
when the Peel and Present option is not attached.
(Upon power-up, the rewinder will turn slowly to
tension the material.)
ENABLED
Enables the rewinder and generates an error if it
cannot be detected. Upon power-up, the rewinder will
turn slowly (for about 30 seconds) to tension the
material and then whenever labels move.
REWINDER ADJUSTMENT
Adjusts the amount of rewinding tension to minimize
TOF registration drift (sometimes evident when using
narrow media), where:
(-30 – 15 %)
00 Decreases or increases the nominal torque by the
percentage selected.