beautypg.com

Performing a hard reset, Performing.a.hard.reset, Preliminar y – Extron Electronics MVX Plus 128 VGA A User Guide User Manual

Page 72: Operation, cont’d

background image

Operation, cont’d

MVX Plus 128 VGA A Matrix Switcher • Operation

3-46

PRELIMINAR

Y

2

.

Release the Reset button and then immediately press and release the Reset

button again. Nothing happens if the second momentary press does not occur

within 1 second.

Performing a hard reset

The hard reset function restores the switcher to the base firmware that it was

shipped with. After a hard reset, events do not automatically start, but user settings

and files are restored. Perform a hard reset as follows:

N

The hard reset restores the factory-installed firmware. The switcher reverts to

that factory firmware the next time power is cycled off and on unless a firmware
update is performed before the power cycle.

1

.

If necessary, turn off power to the switcher.

2

.

Press and hold the Reset button on the rear panel while you apply AC power

to the switcher (figure 3-72).

Power

RESET

RESET

1

2

Press and

hold the Reset button while

you apply power to the switcher.

Release the Reset button.

The switcher flashes the front panel
button indicators

green, red, and

amber and then turns them off.

Continue to hold the Reset button until all input
and output buttons return to either unlit or to
background illumination and the RGBHV or
Video and Audio buttons turn on.

Figure 3-72 — Hard reset