beautypg.com

Creating a configuration, Creating.a.configuration, Preliminar y – Extron Electronics MVX Plus 128 VGA A User Guide User Manual

Page 35

background image

3-9

MVX Plus 128 VGA A Matrix Switcher • Operation

PRELIMINAR

Y

The current configuration and all presets are saved in non-volatile memory. When

power is applied, the most recent configuration is retrieved. The previous presets

remain intact.
If an error occurs during the self-test, the switcher locks up and does not operate.

If your switcher locks up on power-up, call the Extron S

3

Sales & Technical Support

Hotline.

Creating a configuration

The current configuration can be changed using the front panel buttons. Change

the current configuration as follows:

1

.

Press the Esc button to clear any input button indicators, output button

indicators, or control button indicators that may be lit.

2

.

Select to configure video, audio, or both by pressing the RGBHV button

and/or Audio button.

3

.

Select the desired input and output(s) by pressing the input and output

buttons.

Input buttons and output buttons light or blink amber to indicate video

and audio ties, green to indicate video only ties, and red to indicate audio

only ties.

To indicate potential ties, output buttons blink the appropriate color

when an input is selected.

To indicate current ties, output buttons light steadily the appropriate

color when an input is selected.

To clear unwanted outputs, press and release the associated lit output

buttons. To indicate potential unties, output buttons blink the

appropriate color when an output is deselected but not untied from the

input.

4

.

Press and release the Enter button to accept the tie.

5

.

Repeat steps 1 through 4 to create or clear additional ties until the desired

configuration is complete.

N

• Only one video input and one audio input can be tied to an output.

• If a tie is made between an input and an output, and the selected output was

previously tied to another input, the older tie is broken in favor of the newer
tie.

• If an input with no tie is selected, only that input’s button lights.
• When the RGBHV button and Audio button are lit, if an input with an audio

tie but no video tie is selected, the input’s button and the output’s button
light the appropriate color (amber, green, or red).

• As each input and output is selected, the associated output button blinks the

appropriate color to indicate a tentative tie. Buttons for output(s) that were
already tied to the input light the appropriate color steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled off
by pressing the associated output button.

• If you press the input button for an I/O grouped input and then try to select

an output in a different group, you cannot select the associated output
button. The associated input button remains lit.