beautypg.com

Preliminar y, Matrix software, cont’d – Extron Electronics MVX Plus 128 VGA A User Guide User Manual

Page 114

background image

Matrix Software, cont’d

MVX Plus 128 VGA A Matrix Switcher • Matrix Software

5-16

PRELIMINAR

Y

8

.

Click Upload. The File Loader advises you that using the Ethernet (LAN) port

is preferred over using either serial port (figure 5-12).

Figure 5-12 — Confirm window

To quit the firmware upload

and start over using the LAN port, click the

Cancel

button and return to step 3. Use the LAN port connection in step 3.

To continue the firmware upload

using either serial port connection, click the

OK

button. The program prompts you to identify the serial port to which you

are connected. Continue to step 9.

9

.

If necessary, change the port number in the device port field:
• Rear panel RS-232/RS-422 port, enter 1.
• Front panel Configuration port, enter 2.

Click the OK button. The Firmware Loader reports, “This process could take

several minutes. Please wait...

”, then displays a status bar that shows the

progress of the upload. When the upload is complete, the Firmware Loader

reports “Unit resetting, this can take some time, please wait. ...“, and then

Transfer complete!“.

N

Firmware upgrades using either serial port can take several minutes.

10

. When the Firmware Loader reports, “Transfer complete!”, click the Exit button

on the Firmware Loader and then again on the port configuration window.

The Firmware Loader and the Matrix Switchers Control Program exit.