Extron Electronics MVX Plus 128 VGA A User Guide - Manual (Page 119)

5-21 MVX Plus 128 VGA A Matrix Switcher • Matrix Software
PRELIMINAR
Y
Ties as crosspoints — Displays ties as a matrix of inputs and outputs (figure 5-16).
Ties that have been made are indicated as amber (video and audio), green
(video only), and red (audio only) boxes. Ties that will take effect when you
click on the Take button are indicated by +. Ties that will be broken when you
click on the Take button are indicated by –.
Figure 5-16 — Ties shown as crosspoints
Frequency read options — Allows you to set the input signal detection (DSVP)
feature as follows:
• To never sample and display the sync or no sync status
(set this option to None).
• To automatically refresh the display
(set this option to Automatically every 10 seconds).
• To sample the sync and update the display whenever you make a
configuration change (set this option to On demand or by refresh).
Limit ties to same group — Allows you to limit the creation of ties using the
program to inputs and outputs that are in the same group (similar to front
panel operation).
Icons in I/O boxes — Erases any numbers in the I/O boxes in the
Control Program window (figure 5-6). You can place icons in the
boxes.
Numbers in I/O boxes — Erases any icons in the I/O boxes in the
Control Program window and fills each box with the associated
input or output number.
Catch FPC/others changes — When checked, sets the switcher to report all
configuration and setting changes to the Remote RS-232/RS-422 or Ethernet
connection that turned this selection on. These reports allow the Matrix
Switchers Control Program to track the changes that occur in the switcher’s
configuration and settings, whether commanded via the front panel, the
RS-232/RS-422 port, or the LAN port.