Extron Electronics MVX Plus 128 VGA A User Guide - Manual (Page 50)

Operation, cont’d
MVX Plus 128 VGA A Matrix Switcher • Operation 3-24
PRELIMINAR
Y
Example 6: Setting the RGB delay for an output
In the following example, the RGB delay is increased for output 1. The steps show
the front panel indications that result from your action.
1 . Press and release the Esc button (figure 3-34).
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-34 — Clear all selections
2 . Press and hold the RGBHV button for approximately 2 seconds (figure 3-35).
RGBHV RGBHV
Press and hold the RGBHV button until it blinks.
2 seconds
= Blinking button
Figure 3-35 — Select RGB Delay mode
3 . Press and release the output 17 button (figure 3-36).
3 1 2 3
INPUTS
1 2 3 4 5 6 9 10 7 8 1
Press and release the
Output 1 button.
The button lights green.
The Input 1 through Input 10 buttons display the selected output's RGB
delay. Each lit input button indicates half a second of delay.
In this example, the
green input buttons display 3.5 seconds of RGB delay.
3.5 3.0 2.5 2.0 1.5 1.0 0.5
= Unlit button = Lit button
Figure 3-36 — Select an output
N The RGB delay is protected when front panel lock mode 2 is selected. You can
view the delay in lock mode 2, but you cannot change it from the front panel.
If front panel lock mode 2 is selected and you try to perform steps 4, the actions
are ignored and the Enter, RGBHV, and Audio buttons flash.