Extron Electronics MVX Plus 128 VGA A User Guide - Manual (Page 18)

Introduction, cont’d
MVX Plus 128 VGA A Matrix Switcher • Introduction 1-6
PRELIMINAR
Y
Global memory presets — Input/output configurations can be stored in any
of 32 global memory presets. You can then recall those configurations,
when needed, with a few simple steps using the front panel. For the
MVX Plus 128 VGA A, 20 global memory presets are available from the front
panel; the remaining presets are available via serial port control.
Rack mounting — Rack mountable in any conventional 19" wide rack
Three front panel security lockout modes ( Executive modes) — If a matrix
switcher is installed in an open area, where operation by unauthorized
personnel may be a problem, either of two security lockout modes can be
implemented (the third mode is unlocked). When a front panel locked mode
is enabled, a special button combination or SIS command is required to
unlock the front panel controller and make the front panel fully operational.
I/O grouping — This feature allows the matrix to be virtually divided into smaller
sub-switchers, making installation and control easier. I/O grouping allows
specific inputs and outputs, such as those designated for a specific purpose,
to be grouped together. I/O grouping limits the selection of inputs and
outputs to members of the same group.
Power — The matrix switcher’s 100 VAC to 240 VAC, autoswitchable, internal
power supply provides worldwide power compatibility.