beautypg.com

Control buttons, Control.buttons, Preliminar y – Extron Electronics MVX Plus 128 VGA A User Guide User Manual

Page 30: Operation, cont’d

background image

Operation, cont’d

MVX Plus 128 VGA A Matrix Switcher • Operation

3-4

PRELIMINAR

Y

Control buttons

c

Enter button — The Enter button has three primary functions (•) and six

secondary functions (❏):
• Save changes that you make on the front panel. To create a simple

configuration:

Specify RGBHV, audio, or both (see I/O selection buttons [

g

] and

[

h

]).

Press the desired input button (

a

).

Press the desired output button(s) (

b

).

Press the Enter button.

• Indicate that a potential tie has been created but not saved.
• Indicate that a global preset has been selected to be saved or recalled but

that the preset action has not been accomplished.

In the I/O Group mode, select group 1. See “I/O grouping” on page 3-19.

In the I/O Group mode, indicate that group 1 is selected. See “I/O

grouping” on page 3-19.

With the Preset, View, and Esc buttons, select Serial Port Configuration

mode. See “Selecting the rear panel Remote port protocol and baud rate”

on page 3-43.

Select 9600 baud for the RS-232/RS-422 port in Serial Port Configuration

mode. See “Selecting the rear panel Remote port protocol and baud rate”

on page 3-43.

Indicate that the RS-232/RS-422 port is set to 9600 baud in Serial Port

Configuration

mode. See “Selecting the rear panel Remote port protocol

and baud rate” on page 3-43.

With the RGBHV and Audio buttons, select front panel security Lock

mode 2 or toggle between mode 0 (unlocked) and mode 2. See “Setting

the front panel locks (Executive modes)” on page 3-41.

d

Preset button —

The Preset button has two primary functions (•) and five

secondary functions (❏):
• Activates Save Preset mode to save a configuration as a preset and Recall

Preset

mode to activate a previously-defined preset.

• Blinks when Save Preset mode is active and lights steadily when Recall

Preset

mode is active.

In the I/O Group mode, select group 2. See “I/O grouping” on page 3-19.

In the I/O Group mode, indicate that group 2 is selected. See “I/O

grouping” on page 3-19.

With the Enter, View, and Esc buttons, select Serial Port Configuration

mode. See “Selecting the rear panel Remote port protocol and baud rate”

on page 3-43.

Select 19200 baud for the RS-232/RS-422 port in Serial Port Configuration

mode. See “Selecting the rear panel Remote port protocol and baud rate”

on page 3-43.

Indicate that the RS-232/RS-422 port is set to 19200 baud in Serial Port

Configuration

mode. See “Selecting the rear panel Remote port protocol

and baud rate” on page 3-43.