Extron Electronics MVX Plus 128 VGA A User Guide - Manual (Page 152)

MVX Plus 128 VGA A Matrix Switcher • Specifications, Part Numbers, Accessories B
Specifications, Part Numbers, Accessories
PRELIMINAR
Y
B-2
Specifications
Video
Routing ........................................... 12 x 8 matrix
Gain ................................................ Unity
Bandwidth ...................................... 300 MHz (-3 dB), fully loaded
0 - 10 MHz ..................no more than +0.1 dB to -0.1 dB
0 - 130 MHz ................no more than +0.8 dB to -0.8 dB
Crosstalk ......................................... -80 dB @ 1 MHz, -55 dB @ 10 MHz, -45 dB @ 30 MHz, -37 dB @ 100 MHz
Switching speed ............................ 200 ns (max.)
Video input
Number/signal type ..................... 12 RGBHV, RGBS, RGsB, RsGsBs, HDTV, component video, S-video,
composite video
Connectors ..................................... 12 female 15-pin HD
Nominal level ............................... 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ........ Analog: 0.5 V to 2.0 Vp-p with no offset
Horizontal frequency ................... 15 kHz to 150 kHz
Vertical frequency ......................... 30 Hz to 150 Hz
Impedance ..................................... 75 ohms
Return loss ..................................... <-30 dB @ 5 MHz
DC offset (max. allowable)........... 1.5 V
Video output
Number/signal type ..................... 8 RGBHV, RGBS, RGsB, RsGsBs, HDTV, component video, S-video,
composite video
Connectors ..................................... 8 female 15-pin HD
Nominal level ............................... 1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ........ 0 V to 2.0 Vp-p (follows input)
Impedance ..................................... 75 ohms
Return loss ..................................... <-30 dB @ 5 MHz
DC offset ........................................ ±10 mV with input at 0 offset
Sync
Input type ...................................... RGBHV, RGBS, RGsB, RsGsBs
Output type .................................... RGBHV, RGBS, RGsB, RsGsBs (follows input)
Input level ..................................... 0.5 V to 5.0 Vp-p, 4.0 Vp-p normal
Output level .................................. AGC to TTL: 4.0 V to 5.0 Vp-p, unterminated
Input impedance .......................... 510 ohms
Output impedance ........................ 75 ohms
Max input voltage ........................ 5.0 Vp-p
Max. propagation delay ............... 30 ns
Max. rise/fall time ........................ 4 ns
Polarity............................................ Positive or negative (follows input)