beautypg.com

Setting rgb delay, Setting.rgb.delay, Preliminar y – Extron Electronics MVX Plus 128 VGA A User Guide User Manual

Page 49

background image

3-23

MVX Plus 128 VGA A Matrix Switcher • Operation

PRELIMINAR

Y

Setting RGB delay

The switcher can briefly blank the RGB (video) output while it switches to the

new input’s sync source, and then switches the RGB signals. This allows a brief

delay for the display to adjust to the selected input’s sync timing before displaying

the new picture, which then appears without glitches. RGB delay, also known as

Triple-Action Switching or video mute switching, is user selectable from 0 to 5

seconds, in half-second increments.
You can set the RGB delay interval on the front panel or by using the serial ports

and LAN port with either the SIS, Windows control program, or HTML pages. (See

chapter 4, “Programmer’s Guide’; chapter 5, “Matrix Software”; and chapter 6,

“HTML operation”). Specify the RGB delay interval for a specific output on the

front panel as follows:

N

RGB delay is protected when front panel lock mode 2 is selected. You can view

the delay in lock mode 2, but you cannot change it from the front panel.

1

.

Press the Esc button to clear any input buttons, output buttons, or control

buttons that may be lit.

2

.

To enter RGB Delay mode, press and hold the RGBHV button until the button

begins to blink green, then release the button.

3

.

Press and release an output button to select an output. Each lit input button,

from Input 1 through Input 10, indicates a half second of RGB delay interval

for the selected output.

4

.

Press and release the Esc (

>

) and View (

<

) buttons to increase and decrease

the interval.

5

.

Press and release the RGBHV button to exit the RGB Delay mode. The

RGBHV button stops blinking.

N

• Pressing the Enter or Preset button also exits

RGB Delay mode. Pressing

the Preset button changes to

Recall Preset mode.

• The RGB interval for each output is stored in non-volatile memory. When

power is removed and restored, the delay settings are retained.

• Exiting

RGB Delay mode by pressing the RGBHV button always returns

the I/O configuration to audio only selected for configuration.