Extron Electronics MVX Plus 128 VGA A User Guide - Manual (Page 71)

3-45 MVX Plus 128 VGA A Matrix Switcher • Operation
PRELIMINAR
Y
Performing soft system resets
The switchers have three soft resets available that restore various tiers of switcher
settings to their default settings.
• Events (mode 3) reset — This function toggles the monitoring of events on
or off (if events monitoring was on, this function turns it off; if it was off, it is
turned on).
• IP settings (mode 4) reset — The IP settings reset performs the following
functions:

Enables ARP program capability.

Resets the IP address to the factory default (192.168.254.254).

Resets the subnet mask to the factory default (255.255.0.0).

Resets the gateway address to its factory default (0.0.0.0).

Turns DHCP off.

Turns events off.
N IP settings reset does not replace any user-installed firmware.
• Absolute (mode 5) reset — Absolute reset restores the switcher to the default
factory conditions. This function is identical to the Esc ZQQQ SIS command
(see chapter 4, “Programmer’s Guide”).
Perform a soft reset of the switcher as follows:
1 . Use an Extron Tweeker or other small screwdriver to press and hold the rear
panel Reset button until the front panel RGBHV and Audio buttons blink once
(events reset), twice (system reset), or three times (absolute reset) (figure 3-71).
I / O
RGBHV AUDIO
I / O
VIDEO AUDIO
I / O
RGBHV AUDIO
RESET
LAN
RESET
RESET
RESET
RESET
RESET
Press and hold
the Reset button.
Press and hold
the Reset button.
Release, then
immediately
press and release again.
Release, then
immediately
press and release again.
3 seconds
Events Reset
IP Settings
Reset
Buttons and Reset LED flash once.
Buttons and Reset LED flash twice.
Buttons and Reset LED flash three times.
6 seconds
Press and hold
the Reset button.
Release, then
immediately
press and release again.
Absolute Reset
9 seconds
1
2
3
Figure 3-71 — Whole switcher and absolute resets