Delta 1.07 VFD-D D - Manual (Page 39)

Chapter 4 Parameter Settings|DD Series
4-15
Parameter Explanation Settings
Factory
Setting VF VFP SVC FO
C
FO
C
Bit6=0 OD and CD signal are input at the
same time, but without reaction.
Bit6=1 OD and CD signal are input at the
same time and with door
opening
Bit7=0 When the running signal come
from an external terminal.
Pressing OD and CD buttons to
return to running status is not
supported when the drive is
stopped.
Bit7=1 When the running signal come
from an external terminal.
Pressing OD and CD buttons to
return to running status is
supported when the drive is
stopped.
06.11 Position Control Mode
0: No limit signal, detect by PG number
and current level.
1: Door open limit signal only, door close
by PG number or current level
detection.
2: Door close limit signal only，door open
by PG number or current level
detection.
3: Door open and close limit signal
4: Detect by PG number and also accept
external door open/close limit signal
5: No limit signal, detect by PG number
and current level. (For Pr.00-09=3
speed control mode)
0 ○ ○ ○ ○ ○
06.12 Stall Current Level of
Position Mode
0.0~200.0% (Drive’s rated current) 30.0 ○ ○ ○ ○ ○
06.13 Door Open/Close Holding
Time Before Next Demo
0.0~99.99sec 2.0 ○ ○ ○ ○ ○
06.14 Times of Door Open/Close
in Demo Mode (L) 0~9999 0 ○ ○ ○ ○ ○
06.15 Times of Door Open/Close
in Demo Mode (H) 0~9999 0 ○ ○ ○ ○ ○
06.16 Clear Demo Mode Door
Open/Close Record 0: Disable
1: Clear (Pr.06.14 and Pr.06.15) 0 ○ ○ ○ ○ ○
06.17 Present Fault Record 0: No fault 0 ○ ○ ○ ○ ○
06.18 2nd Most Recent Fault
Record 1: Over-current during acceleration
(ocA)
0 ○ ○ ○ ○ ○
06.19 3rd Most Recent Fault
Record 2: Over-current during deceleration
(ocd)
0 ○ ○ ○ ○ ○
06.20 4th Most Recent Fault
Record
3: Over-current during steady speed
(ocn)
0 ○ ○ ○ ○ ○
06.21 5th Most Recent Fault
Record 4: Reserved 0 ○ ○ ○ ○ ○
06.22 6th Sixth Most Recent Fault
Record 5: Reserved 0 ○ ○ ○ ○ ○