Delta 1.07 VFD-D D - Manual (Page 23)

Chapter 3 Keypad and Startup |DD Series
3-2
3-1 Operation Method
The factory setting of VFD-DD series AC motor drive’s operation method is set to external terminal
control. But it is just one of the operation methods. The operation method can be via
communication, control terminals settings or optional digital keypad. Please choose a suitable
method depending on application and operation rule.
Operation Method Frequency Source Operation Command Source
Operate from
communication
Please refer to the communication address 2000H and 2119H settings in
the communication address definition.
Control Terminals-
Operate from external
signal
NOTE
24V
OD
CD
MI1
MI2
MI3
MI4
MI5
DCM
Multi-Function
Input Terminals
COM
Door Open
Door Close
Open Limit Input
Close Limit Input
Door Open Speed Switch
Door Open Speed Switch
No Function
Digital Signal Common
E Do not apply mains voltage directly
to the above terminals
Main circuit Output Terminal
Control Terminal
Shielded Leads & Cables
Figure 3-1
Figure 3-2
Digital Keypad
UP/DOWN key RUN, STOP/RESET key