ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 293)

GS-4012F/4024 User’s Guide
292 Chapter 42 IEEE 802.1Q Tagged VLAN Commands
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
Figure 198 frame type Command Example
42.5.3 Enable or Disable Port GVRP
Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable
GVRP.
The following example turns off GVRP for ports 1 to 5.
Figure 199 no gvrp Command Example
42.5.4 Modify Static VLAN
Use the following commands in the config-vlan mode to configure the static VLAN table.
Syntax:
vlan
fixed
forbidden
name
normal
untagged
no fixed
no forbidden
no untagged
where
• Enter fixed to register the to the static VLAN table with .
• Enter normal to confirm registration of the to the static VLAN table with
.
ras (config)# interface port-channel 1-5
ras (config-interface)# frame-type tagged
ras (config)# interface port-channel 1-5
ras (config-interface)# no gvrp
= The VLAN ID [1 – 4094].
= A name to identify the SVLAN entry.
= This is the switch port list.