ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 263)

GS-4012F/4024 User’s Guide
262 Chapter 40 Introducing the Commands
broadcast-limit Disables broadcast storm
control limit on the port(s).
diffserv Disables DiffServ on the port(s).
dlf-limit Disables destination lookup
failure (DLF) on the switch.
egress-set
list>
Disables the egress port setting.
flow-control Disables flow control on the
port(s).
gvrp Disable GVRP on the port(s).
igmp-filtering
profile
Disables IGMP filtering.
igmp-group-limit Disables IGMP group limitation.
igmp-immediate-
leave
Disables the IGMP immidiate
leave function.
inactive Enables the port(s) on the
switch.
ingress-check Disables ingress checking on
the port(s).
intrusion-lock Disables intrusion-lock on a port
so that a port can be connected
again after you disconnected
the cable.
mirror Disables port mirroring on the
port(s).
multicast-limit Disables multicast limit on the
port(s).
vlan-trunking Disables VLAN trunking on the
port(s).
pvid <1-4094> The default PVID is VLAN 1 for
all ports. Sets a PVID in the
range 1 to 4094 for the specified
interface.
qos priority <0 .. 7> Sets the quality of service
priority for an interface.
speed-duplex
full|100-half|100-
full|1000-full>
Sets the duplex mode ( half or
full ) and speed ( 10 , 100 or
1000 Mbps) of the connection
on the interface. Selecting
auto (auto-negotiation) makes
one port able to negotiate with a
peer automatically to obtain the
connection speed and duplex
mode that both ends support.
spq Sets the port(s) to use Strict
Priority Queuing.
test Performs an interface loopback
test.
Table 96 interface port-channel Commands (continued)
COMMAND DESCRIPTION