ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 258)

GS-4012F/4024 User’s Guide
Chapter 40 Introducing the Commands 257
no area
virtual-link
authentication-
same-as-area
Resets the authentication
settings on this virtual area.
no area
virtual-link
Deletes the virtual link from the
area.
no network
addr/bits>
Deletes the OSPF network.
no redistribute
rip
Sets the switch not to learn RIP
routing information.
no redistribute
static
Sets the switch not to learn
static routing information.
redistribute rip
metric-type <1|2>
metric <0-65535>
Sets the switch to learn RIP
routing information which will
use the specified metric
information.
redistribute
static metric-
type <1|2> metric
<0-65535>
Sets the switch to learn static
routing information which will
use the specified metric
information.
rip Enables and enters the RIP
configuration mode.
exit Leaves the RIP configuration
mode.
vrrp network
address>/
vr-id <1-7> uplink-
gateway
Adds aa new VRRP network nd
enters the VRRP configuration
mode.
exit Exits from the VRRP command
mode.
inactive Disables the VRRP settings.
interval <1..255> Sets the time interval (in
seconds) between Hello
message transmissions.
name
string>
Sets a descriptive name of the
VRRP setting for identification
purposes.
no inactive Activates this VRRP.
no preempt Disables VRRP preemption
mode.
no primary-
virtual-ip
Resets the network to use the
default primary virtual gateway
(interface IP address).
no secondary-
virtual-ip
Sets the network to use the
default secondary virtual
gateway (0.0.0.0).
Table 95 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION